Campbell-hausfeld HL5401 Series Manuel d'utilisateur télécharger pdf (Page 6)

6

Operating Instructions

www.chpower.com

Maintenance (Continued)

INTAKE AIR FILTER MAINTENANCE

Removal, Inspection and Replacement

(Figure 9).

The intake filter element should be

removed and checked periodically.

A clogged intake filter can decrease

compressor performance and cause the

compressor to overheat.

1. Rotate the ﬁlter cover counter-

clockwise and remove.

2. Remove the ﬁlter element and

inspect.

3. If the ﬁlter element is dirty or

clogged, replace it.

4. Reinstall ﬁlter and cover.

IMPORTANT: Locate unit as far from

spraying area as hose will allow to

prevent overspray from clogging filter.

END OF OPERATION/STORAGE

1. Turn AUTO/OFF switch to the OFF

position.

2. Unplug power cord from wall outlet

and wrap around handle to prevent

damage when not in use.

3. Wearing safety glasses drain tank of

air by pulling the ring on the safety

valve. Use other hand to deflect

fast moving air from being directed

toward your face.

4. Drain tank of condensation by

opening drain valve on bottom of

tank. Tank pressure should be below

10 psi when draining tank.

5. Air hose should be disconnected

from compressor and hung open

ends down to allow any moisture to

drain.

6. Compressor and hose should be

stored in a cool, dry place.

TECHNICAL SERVICE

For information regarding the

operation or repair of this product,

please call 1-800-543-6400.

MAINTENANCE SCHEDULE

OPERATION DAILY WEEKLY MONTHLY 3 MONTHS

CHECK OIL LEVEL

l

DRAIN TANK

l

CHECK AIR FILTER

l

CHECK SAFETY VALVE

l

CLEAN UNIT

l

CHANGE OIL

l

Figure 9 - Intake Filter Maintenance

Filter

Element

Filter

Cover

MOISTURE IN COMPRESSED AIR

Moisture in compressed air will form

into droplets as it comes from an air

compressor pump. When humidity

is high or when a compressor is in

continuous use for an extended

period of time, this moisture will

collect in the tank. When using a

paint spray or sandblast gun, this

water will be carried from the tank

through the hose, and out of the

gun as droplets mixed with the spray

material.

IMPORTANT: This condensation will

cause water spots in a paint job,

especially when spraying other than

water based paints. If sandblasting, it

will cause the sand to cake and clog

the gun, rendering it ineffective.

A ﬁlter in the air line, located as

near to the gun as possible, will help

eliminate this moisture.

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Commentaires sur ces manuels

Pas de commentaire